About this deal
Part: 32-34465 Fabrication and aluminum welding required. These aluminum hose neck kits make it easy to rebuild your aluminum radiator. Includes a 1-1/2" and a 1-3/4" neck, weld-in 1/4" NPT fitting, hose barb and petcock. RadiatorWeld™ is a plastic tank and radiator repair kit designed for permanent or temporary repairs on both metal and plastic radiators and plastic liquid storage containers from leaks caused by cracks of 4" or less and holes up to 1/4" diameter. This kit is not recommended for plastic repairs or for use with polyethylene or polypropylene plastic parts.
- 1-3/4" tube = 3" long
- 1-1/2" tube = 2-1/2" long
Reviews
Jack Hart
Then I hand sanded it with a small piece of 100 grit sandpaper until the surface looked rough. I checked it after about 5 minutes and it had set and was hard. Then I cleaned the area with a wet paper towel and dried it with a dry paper towel.
Mark
It could not have been easier. Definitely was worth it for me because the car is getting old and has other problems so I didn’t want to put too much money into it. Then I put on rubber gloves and cut the corners off both of the epoxy pouches and dispensed approximately half of the black epoxy and half of the white epoxy into two separate blobs on the cardboard.