About this deal
Details: Drilax 6 inch Diamond Hole Saw Drill Bit Tiles, Glass, Fish Tanks, Marble, Granite, Ceramic, Porcelain, Coated Core Bits Holesaw DIY Kitchen, Bathroom, Shower, Faucet Installation The diamond particule coating on DRILAX hole saws give superior performance and lifetime. Here is how you could use water to keep the tool cool: a- You can build a mini water pool around the hole with plumbers putty. Electroplated diamond coating will wear off if the tool gets too hot. Back plate design - The back plates are constructed with thick steel thus the holes will not enlarge over time. Please use protective gear.
- HIGH QUALITY, DURABLE Diamond Coated Hole Saw Tool True 6 inches Diameter
- TRUE 6 Inch - Hard to Find Diamond Tool for DIY Kitchen, Bathroom, Shower, Ceiling Light Installation Projects
- DRILAX Quality - We are here to help.
- Does not have a center pilot drill.
- STANDARD 3/8 inch Shank Use with and standard electric or cordless drill.
Reviews
Amazon Customer
A loose grip can result in the hole saw catching and possible injury if the drill is jerked out of the user's hands. 4. Make sure to start on one side and drill part way then turn over and finish the cut. When through the drilled material, continue operating the drill slowly in the forward direction as you withdraw it.
Donald J.
More experienced users may skip this step by keeping the bit in the arbor and drilling very slowly, keeping the bit perpendicular and the bottom of the hole saw parallel to the surface being cut so it all comes into contact simultaneously. With the lack of instructions (resulting in a 4.
Rick Dorsino
Hold on the the drill because if you have a good drill this could spin that around no tweek your wrists pretty good. Much better than doing it with a jig. My preferred way is to have a piece of scrap wood clamped securely to the underside of the piece you're drilling (which allows for a continuous drilling operation and the hole being perfectly aligned through the entire hole.
T. Fagan
I used these to make 4 corn hole boards. 2.
Ferrone
fast too The alternate method where clamping isn't possible is to drill half to 3/4 of the way through (so the pilot hole goes all the way through), stop, and switch to the other side to drill the other half of the hole.
Vwking2000
. We’ve used this to make several corn hole boards now and it works very well. This is awesome I needed to cut a 6 inch hole in soft metal and install a vent into a custom electronics box for portable wind and solar.